Assigning VLAN to an Interface: Exploring Configuration Commands
What is the correct command to assign a VLAN to an interface?
A. Switch(config)#interface fastEthernet 0/1 Switch(config-if)#switchport mode trunk Switch(config-if)#switchport access vlan 10 B. Switch(config)#interface fastEthernet 0/1 Switch(config-if)#switchport mode access C. Switch(config)#interface fastEthernet 0/1 Switch(config-if)#switchport mode access Switch(config-if)#switchport access vlan 10 D. Switch(config)#interface fastEthernet 0/1 Switch(config-if)#switchport mode trunk Switch(config-if)#switchport access vlan 10
Final answer: The correct command to assign a VLAN to an interface is Switch(config)#interface fastEthernet 0/1, Switch(config-if)#switchport mode access, Switch(config-if)#switchport access vlan 10.
Answer:
The correct command to assign a VLAN to an interface is Switch(config)#interface fastEthernet 0/1, Switch(config-if)#switchport mode access, Switch(config-if)#switchport access vlan 10.
To assign a VLAN to an interface on a switch, you need to use specific configuration commands. In this scenario, the correct commands are as follows:
Switch(config)#interface fastEthernet 0/1: This command selects the FastEthernet interface 0/1 for configuration.
Switch(config-if)#switchport mode access: This command sets the mode of the interface to access, indicating that the interface will be used to connect end devices to a specific VLAN.
Switch(config-if)#switchport access vlan 10: This command assigns VLAN 10 to the interface, meaning that any device connected to this interface will be part of VLAN 10.
By following these commands in the correct sequence, you can effectively assign a VLAN to an interface on a switch. It is essential to configure interfaces correctly to ensure proper network segmentation and traffic management.