Complete the Install an Embedded OS Lab and Hands-On Project 12-5

What are the steps to complete the Install an Embedded OS Lab and Hands-On Project 12-5, and what are the requirements for each step?

Completing the Install an Embedded OS Lab

To complete the Install an Embedded OS Lab, you need to follow the steps outlined below:

  1. Access Brightspace and navigate to the week's lab section.
  2. Download the Lab pdf file provided.
  3. Follow the instructions in the Lab pdf to install an embedded OS.
  4. Submit your answers on the Answer sheet .doc file located in the week's lab section.

Completing Hands-On Project 12-5

For Hands-On Project 12-5, follow the steps mentioned:

  1. Download the UFED reader from the provided link.
  2. Download the logical and physical UFDR files from the book companion site.
  3. Install and launch the UFED reader.
  4. Open the logical UFDR file, go to the 'Messages' tab to capture SMS messages screenshot.
  5. Open the physical UFDR file, capture SMS messages screenshot from the 'Messages' tab.

To complete the Install an Embedded OS Lab, access Brightspace and download the Lab pdf file from the week's lab section. Follow the instructions provided in the pdf to install the embedded OS. After installation, submit your answers on the Answer sheet .doc file within the lab section.

For Hands-On Project 12-5, download the UFED reader and logical and physical UFDR files from the respective sources. Install the reader, open the logical UFDR file to capture SMS messages screenshot. Then, open the physical UFDR file and take screenshots of SMS messages as well.

Make sure to include the SMS messages screenshots from both logical and physical acquisitions in your submission for a successful completion of the tasks.

← The three different ways to control vlans in a virtual switch configuration Understanding seat designations on aircrafts →

More Posts: