Placing Copper Tubing in a Flaring Kit

Where should copper tubing be placed in a flaring kit?

Should it be:

A. slightly over the edge of the kit B. above the kit C. even with the edge of the kit D. below the kit

Answer:

Copper tubing should be placed slightly over the edge of the flaring kit to ensure a proper flare.

In a flaring kit, copper tubing should be placed slightly over the edge of the kit. This allows for proper flaring of the tubing end to create a secure connection. Placing the tubing above or even with the edge of the kit may not provide enough material for the flare, while placing it below the kit would result in an improper flare.

To achieve the best results and ensure a secure connection, it is important to follow this placement guideline when using a flaring kit with copper tubing. Proper placement can make all the difference in the effectiveness and durability of the connection.

← Transformer vaults let s dive into electrical systems design Calculate the mass flux when water flows through a pipe of varying diameter →

More Posts: